I need my Cisco 1900/1941 router configured for internet port forwarding from the internet to my internal NAS/Webserver.
DYNDNS already setup.
SSH to router already setup
I just cant figure out how to HTTP & HTTP port forwarding to my NAS.
Hi Experts, I am looking for a solution to switch IPs automatically when using an online crawler. You should have an experience with both crawling and IP switching concept over social networking sites. Any suggestion such as an application or switching device is welcome. Thanks,
hi! we will development of networking monitoring tool. its required technology L2,L3 and L7. 1.we will try to capture in LAN traffic through a SWITCH. 2.we will try to capture with LAN traffic from same subnet. ==> and we will monitoring.
We have attached below clients literature review ... Dissertation minimum words length is 12500 and maximum is 15000...
Scope of project: - Ipv6 address planning for CPEs and the prefix delegation to the hosts behind CPE (DHCPv6) - Ipv6 provisioning configuration on subinterfaces configured with specific VLANs - ipv6 prefix delegation for hosts behind CPE through DHCPv6 - Adapting/reconfiguring all the current...
i have a cisco 7965G phone with SIP firmware version 9.3, and i have the TFTP server and the XML file for provisioning, but the phone dose not register, (maybe i have something wrong in my XML file,) i would like my phone to be fully configured with my sip server, with no error messages like asking